This is the top of the box. In the middle of the snowflakes I put a Build A Brad. These are AMAZING! You just punch anything out using a 1/2" circle punch, put it on the metal post, and then put the clear bubble on top. Voila! A custom brad for whatever your project is! For the center of this brad, I punched a circle out of another sheet of Ski Slope Designer Series Paper.
Here is the box lid off the box...with the cards inside.
A side view of the box.
A close up of the Felt Flurry with the Build A Brad.
Here are the 4 cards that go in the box. So similar, yet so different. :)
This is a close up of just one of the cards.
Close up of the Felt Flurries. In the middle of 2 of the Felt Flurries, I put just a Rhinestone Brad. In the middle of 2 of the Felt Flurries, I put a Jumbo Eyelet and then a Rhinestone brad in the hole of the brad.
I even lined the envelopes! Wow....I'm going on the way with this one! :) But I lined the inside with the same DSP pattern that I put on the cards. And then I put a strip of DSP on the bottom of the front of the envelope.
Hope you enjoyed!